How to connect the plate Tricolor?

Watch the video

"Tricolor TV" is a popular satellite operator,which offers customers an extensive list of channels of different focus. To get access to them, you need to purchase a plate, and then properly install and configure it. Let's consider further how to do this work yourself.

Installation of the dish "Tricolor TV": instruction

To install the "Tricolor TV" dish correctly, do the following:

Identify the place where it will be installedsatellite antenna. In order for it to work correctly, it is necessary to find a point where the roof visors, pipes and other elements will not obstruct the reception of the signal. At the same time, keep in mind that the satellite is in the south. Therefore, it is better to choose a place for installing the antenna on this side. In this apartment, you can put a plate directly on the balcony, in a private house - on the roof.
Proceed to assembly the antenna. Do this in accordance with the instructions attached to it.
Fix the bracket with the holder in the place,where it is planned to install a plate. Fasteners for it must be chosen reliable, depending on the material of the surface on which the installation takes place, and wind load.
Install the convector. It is fixed directly into the holder, always with the connector down, so that moisture does not get inside.
Connect the cable to the convector suppliedto the plate, into the corresponding connector. Then attach it to the arch of the holder using plastic ties or an insulating tape. Then the made connection to the convector should be isolated with the help of paint tape and silicone sealant.
Install the antenna on the bracket. Be sure to lock it using the adjusting nuts. But do not twist them too tightly, otherwise you will not be able to subsequently move the plate in the vertical and horizontal planes for adjustment.

Setting the dish

Install and connect the antenna "Tricolor TV" - this is half the battle, you must also configure it. To do this, you need to do the following:

Connect the cable from the convector to the LNB IN connector to the receiver.
Connect the receiver to the TV (follow the instructions for it) using the cord that comes with it.
Turn on the TV, and then go to the plate and start smoothly moving it horizontally until the signal appears on the receiver.
On the remote that goes to the receiver, select "Menu", and in it - "Automatic search" and wait until all channels are found.

You can also use these articles and sections: