How to use the scanner?
If you have to deal with an officetechnology, it will not be difficult for you to deal with new or unusual equipment. If you do not know which way to go to fax, and the copier and scanner cause a nervous thrill in you - learn to treat them correctly. So, how to use the scanner? This device is extremely necessary in any office. At home, the scanner will not be superfluous either. With it, you can convert any picture or text into digital format.
How to start the scanner
First of all, you will need to connect the device to thecomputer and correctly configure it. Connect the scanner via the USB port to the computer. Do not forget to turn on the device on the network. Now you need to insert the installation disk into the computer, which must be in the box with the scanner. After installing the special drivers, your scanner must be "visible" to the computer.
Sometimes for some reason, the installation disk is missing. Then you need to try to find a suitable driver on the network.
We hope that you managed to configure the scanner. How to turn on the scanner and how to use it, we'll explain below.
Operating Instructions for the Scanner
In order for the scanner to perform its functions,you will need one of the programs that can scan. Usually it is: Adobe Fotoshop, XnView, VueScan. In fact, there are a lot of such programs. In order to verify your capabilities, find the "file" menu in the program interface, open it. Then find the "import" submenu and make sure that there is a line in it that contains the model of your scanner.
Now proceed as follows.
- Place the document or photo for scanning on the machine's glass so that the image is on the bottom.
- The scanner may have a "start" or "scan" button. Click it. In some cases, you can start scanning using an open program on your computer.
- An image of your document should appear on the screen. Now you can use the dotted lines to select the desired image size. That is, cut off unnecessary.
- How to work with the scanner? At this point, it is desirable to optimize the image parameters. You can change the resolution - the bigger it is, the better the picture will turn out, however, its "weight" will also increase. You can change the brightness and saturation of a certain color.
- All you saw was a preview. Now you just need to click the "scan" button in the program interface, sometimes "accept".
- Save the image. To do this, in the "file" menu, find the "save" submenu and specify the address of the folder.
Your image is digitized. Now it can be sent by e-mail, upload to Twitter, or you can make a wallpaper for it from your desktop.
How to use the scanner
Scanner - the device is not cheap, and to work it for a long time, without problems and hangs, treat it neatly. How to use the scanner?
- It is extremely cautious to treat the glass in the apparatus. This is one of its main elements. If the glass is in spots and scratches - the image will be poor.
- Before placing the document in the device, dust it off, if any. Do not stack dirty objects or abrasives on the glass.
- Do not apply pressure to the glass.
- Do not clean the scanner glass with powder.
Experts also recommend thatdocument before scanning. If you make a high resolution, all minor defects will be visible on the scan. Therefore, before stacking a picture in the scanner, check it for unnecessary staples, folds, pieces of scotch. It is recommended that you even remove fingerprints, which can be done with an eraser or a soft flannel.
We hope that you were able to install and runscanner. After all, today such a device should no longer cause difficulties for a modern person. Try, hone your skill, and then any technique will be obedient to you in the summer.
