How to connect multitronics?

Watch the video

How to connect multitronics?

Today, on-board computers in the car playa huge role in the life of the motorist. They tell the driver useful data like fuel consumption, engine condition and other machine systems and even the temperature in the cabin. That's why many drivers install on-board computers today.

One of the best on-board computersis considered on-board computer Multitronics. Usually motorists come to the service to install a computer in the car, however, some motorists prefer to do it themselves.

Let's take a closer look at how to connect Multiotronics independently in the car.

How to connect Multitronics

To connect an on-board Multitronics computer you need to perform a number of actions:

1. The first thing you need to find a place where it is more convenientjust install the on-board computer. The onboard computer in this case should be in front of the driver's eyes and at the same time not interfere with the road survey. Therefore, do not install Multitronics on the glass, also do not install on the torpedo, because every time you have to mess with it. The best option is to place the on-board computer between the rearview mirror and the ceiling. However, for this you have to lower the mirror a little lower.
2. Then it is necessary to disconnect the battery terminal of the car to connect the new electronics.
3. We extend the cable to connect the on-board computer through the sun visor. To do this, you can not remove the visor, but use wire for broaching.
4. All the wires can be stretched on the floor under the mats, so they do not interfere.
5. We connect the wires of the onboard computer with the ignition and the cigarette lighter to create a "Physical lock".
6. We disassemble the door for connecting the fuel sensors. For this we find under the driver's seat two light pads. We choose to connect the nearest, because from the far will have to tinker. Usually, the fuel sensor wire is green in the on-board computer. If the color is different, then you should see the color of the wire in the documentation. We connect the wire of the fuel sensor to the gray under the nearest shoe.
7. We turn on the car battery and try to turn on the on-board computer.

If everything went well, then onlyconfigure the multitronic computer and check the readings of the sensors. If the connection is not correct, you will have to turn off the battery and repeat the connection procedure again. All useful data you can always find in the documentation.

Also you can read our article Car accessories.